Ample power for sole-source heating* or alternatively use to simply take the chill off the floor.
*Providing the room is adequately insulated.
This underfloor heating mat requires a thermostat control purchasable separatly.
Please see our other listings for underfloor heating mat and thermostat combinations.
The use of insulation boards will reduce heat up times and running costs by up to 50%. This means they can pay for themselves in just 2-3 years.
This heating is suitable for installation onto timber floors which have been over boarded with a minimum of 15mm exterior or marine quality ply.
Stable timber floorboards or 22mm chipboard flooring which have not been over boarded will require installation boards installed to provide a thermal barrier between the heat mat and the timber.
Heat Mat Size Selection
Before selecting your heating it is vital to ensure you have the correct size heat mat to suit your room. This is critical as the heating element CANNOT be reduced or extended.
Always round DOWN to the nearest size. It is always best to have a little less heating than some left over!
Full installation instructions can be found in the data sheets section below
If you need any further advice please call us on 01473 805959 or drop us an email at [email protected]
|Suitable for use under||Tiles - Ceramic, Porcelain & Natural Stone|
|Wattage Output||200w / m²|
|Heat Mat Guarantee||25 Years|
|Certification||CE, ROHS, TUV|
|Element Structure||Dual Core Wire|
|Cold Tail Length||3m|
|Earth Type||100% Coverage Earth Shield|
|Power Supply||AC230V +/-10% 50/60Hz|
|Total Output||SEE DATA SHEETS ABOVE FOR INDIVIDUAL SIZES|
|Current Load||See Data Sheets Above For Individual Sizes|
|Resistance Value||See Data Sheets Above For Individual Sizes|
|Heat Mat Dimensions||See Data Sheets Above For Individual Sizes|
|Product Instructions||BodenWarme Underfloor Heating Instruction Manual 200w/m|
This featured is only available on our Tile pages. As it takes into account the dimensions of the Tile you are viewing.