Apply setting material according to manufacturer's instructions. Slide two clips under the tile approximately 50mm from each end of the tile. (If a wider grout joint is required, please use in conjunction with a traditional type of spacer.) Then place the next tile into position.
Slide a reusable wedge into each clip across both tiles. Push tight until tiles are firm underneath the wedge. Then adjust tiles so the tile edges are aligned and firmly held into position by clip and wedge.
Allow the tile adhesive to dry as in accordance with the manufacturer's instructions. When the adhesive has dried and the floor is firmly set remove the protruding clip and wedge by gently kicking the top, the clip is designed to break off at this point. Keep the reusable wedges for your next tiling project. In the instance of using LASH spacers on a wall tiling project, use a non marking rubber mallet to remove the tops of the clips.